It would be nice if the Sparc install manual mentioned that silo-1.2.6 is incapable of loading second stage boot information from a partition created with reiserfs. In particular, /boot should be ext2. Because silo can't read from a reiserfs partition, /etc/silo.conf must be copied to /boot. Also, at least on my system, formating /dev/hda1 with reiserfs seemed to trash the disk label. (Though perhaps I did something else stupid.) Consequently, I suggest that conservative installs put /boot on /dev/hda1 Reproducible: Always Steps to Reproduce: 1. 2. 3.
Will add a note to install guide Thanks
reassigning to the sparc document dev
Addressed in 1.4 install doc.