With ttyS0, minicom conflict with mouse and keyboard in x-window, when output rolling. it's ok in virtual terminal. With ttyS1, output is normal, but no keyboard. This occurs after I install 2006.1. I tried ubuntu's xorg.conf and livecd's kernel and module, the result is the same. If this is my fault, sorry for disturbing. Reproducible: Always Steps to Reproduce: 1. Install gentoo using livecd 2006.1, with gnome and xorg 2. emerge --sync, emerge minicom 3. in x-window, sudo minicom, then config Serial port setup Serial Device : /dev/ttyS0 Bps/Par/Bits : 115200 8N1 Hardware Flow Control : No Software Flow Control : No then choose exit 4. start develop board. Actual Results: the cursor jumped here and there, right button menu spring out repeatedly. At last X-window may die. Expected Results: Output scroll down normally, shouldn't influence the host.
I will take a wild guess and assume your X is configured to use the mouse connected on ttyS0. Please use forums if you what this kind of support.
I meant "if you want this kind of support", obviously. Sorry for typo.
(In reply to comment #1) > I will take a wild guess and assume your X is configured to use the mouse > connected on ttyS0. > Please use forums if you what this kind of support. > Thank you for your kindness.
