Bug 445730 – net-wireless/wpa_supplicant-1.1 - Version bump.

• Product: Gentoo Linux
• Status: RESOLVED FIXED

[Description teidakankan 2012-12-03 04:28:23 UTC]

http://hostap.epitest.fi/releases/wpa_supplicant-1.1.tar.gz

Reproducible: Always




ChangeLog for wpa_supplicant

2012-11-06 - v1.1
	* Fix EAPOL supplicant port authorization with PMKSA caching.
	* Fix EAPOL processing when STA switches between multi-BSSes.
	* Fix EAP-FAST with OpenSSL 1.0.1.
	* EAP-pwd: Increase maximum number of hunting-and-pecking iterations,
	  which results in less authentication attempts failing.
	* Set state to DISCONNECTED on AP creation errors. Previously the
	  supplicant would stay in SCANNING state forever.
	* Fix REMOVE_NETWORK to not run operations with invalid current_ssid.
	* EAP-SIM peer: Fix AT_COUNTER_TOO_SMALL use.
	* Interworking: Fix PLMN matching with multiple entries to compare all
	  entries, not just the first one.
	* Handle long configuration file lines more gracefully.
	* Fix adding extra IEs in sched scan.
	* PMKSA: Set cur_pmksa pointer during initial association.
	* PMKSA: Do not evict the active cache entry when adding new ones.
	* Set state consistently to DISCONNECTED on auth/assoc failures.
	* Fix BSSID enforcement with driver-based BSS selection. Set BSSID and
	  channel when the network block has an explicit bssid parameter to
	  select which BSS is to be used.
	* wpa_gui: Fix compilation with gcc/g++ 4.7.
	* EAP-AKA'
	  - Update to RFC 5448 in the leading characters used in the username.
	    This will make EAP-AKA' not interoperate between the earlier draft
	    version and the new version.
	  - Fix SIM/USIM determination to support EAP-AKA'.
	* dbus:
	  - Add global capabilities property.
	  - Fix bss_expire_count getter, which was returning the wrong value.
	  - P2P: Remove network_object dictionary entry from signal
	    GroupStarted.
	  - Fix D-Bus build without ctrl_iface.
	* WPS:
	  - Fix nonce comparisons to compare all bytes, not just the first byte.
	  - Fix NFC password token building with WPS 2.0 to avoid wpabuf
	    overflow and application abort if NFC out-of-band mechanism is used
	    with WPS 2.0 enabled.
	  - Fix cleanup of WPS operations (by clearing them) in WPA_SCANNING
	    and WPA_DISCONNECTED states.
	  - Fix issue with BSSID filter handling that could cause only a single
	    one of the available BSSes to be available or could cause issues
	    connecting.
	  - Fix overlapping memcpy on WPS interface addition.
	* P2P:
	  - Remove channel 14 from supported P2P channels.
	  - Fix Provision Discovery retries on delay in off channel
	    transmission, to avoid unnecessary retries.
	  - Limit maximum number of stored P2P clients (the p2p_client_list
	    parameter) to 100.
	  - Improve p2p_client_list updates in configuration file, reording
	    entries so that the most recently added values are maintained in
	    the list if the list gets truncated due to size.
	  - Fix Provision Discovery retries during p2p_find by making the
	    p2p_find case behave consistently with the limited retry
	    behavior used with Provision Discovery retries in the IDLE state.
	  - Fix P2P Client Discoverability bit updates so that the bit is only
	    updated based on P2P Group Info attribute from a GO.
	  - Fix GO Negotiation race condition where both devices may believe
	    they are the GO. (Ignore unexpected GO Neg Response if we have
	    already sent GO Neg Response.)
	  - Deinitialize global P2P context on P2P management interface removal.
	  - Wait 100 ms if driver fails to start listen operation. This is a
	    workaround for some drivers that may accept the remain-on-channel
	    command, but instead of indicating start event for
	    remain-on-channel, just indicate that the operation has been
	    cancelled immediately.
	  - Clone max_sta_num parameter for group interfaces, allowing this
	    parameter set in the main config file to apply to dynamically
	    created P2P group interfaces.
	  - Fix Device ID matching for Probe Request frames, which was checking
	    only the first octet of the P2P Device Address.
	  - Do not update peer Listen channel based on PD Request Invitation
	    Request frames (just on Probe Response frames).
	  - Fix p2p_listen to disallow scheduling a new after scan operation
	    in the case where a p2p_connect operation is pending.

[Comment 1 Bjarke Istrup Pedersen (RETIRED) 2012-12-03 09:25:38 UTC]

Fixed, version 1.1 should be hitting the rsync mirrors within an hour.