ase: 00000000 On node 0 totalpages: 65536 zone(0): 65536 pages. zone(1): 0 pages. zone(2): 0 pages. Kernel command line: root=/dev/ram rw ramdisk_size=24000 PowerMac using OpenPIC irq controller OpenPIC Version 1.2 (4 CPUs and 64 IRQ sources) at fc670000 OpenPIC timer frequency is 4.166666 MHz GMT Delta read from XPRAM: 60 minutes, DST: off time_init: decrementer frequency = 24.966218 MHz Console: colour dummy device 80x25 Calibrating delay loop... 797.90 BogoMIPS Memory: 246124k available (3244k kernel code, 1844k data, 308k init, 0k highmem) AGP special page: 0xcffff000 Dentry cache hash table entries: 32768 (order: 6, 262144 bytes) Inode cache hash table entries: 16384 (order: 5, 131072 bytes) Mount-cache hash table entries: 4096 (order: 3, 32768 bytes) Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes) Page-cache hash table entries: 65536 (order: 6, 262144 bytes) POSIX conformance testing by UNIFIX Entering SMP Mode... SMP not supported on 750 cpus. smp.c line 332 Waiting on wait_init_idle (map = 0x0) All processors have done init_idle PCI: Probing PCI hardware Fixup res 1 (101) of dev 00:10.0: 400 -> 802400 Can't get bus-range for /pci@f2000000/cardbus@1a PCI->OF bus map: 0 -> 0 1 -> 0 6 -> 0 PCI:00:10.0: Resource 0: b4000000-b7ffffff (f=1208) PCI:00:10.0: Resource 2: b0000000-b0003fff (f=200) PCI:01:17.0: Resource 0: 80000000-8007ffff (f=200) PCI:01:1a.0: Resource 0: a0000000-a0000fff (f=200) PCI:06:0f.0: Resource 0: f5200000-f53fffff (f=200) PCI:00:10.0: Resource 1: 00802400-008024ff (f=101) PCI:01:18.0: Resource 0: a0002000-a0002fff (f=200) PCI:01:19.0: Resource 0: a0001000-a0001fff (f=200) PCI:06:0e.0: Resource 0: f5000000-f5000fff (f=200) Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket Thermal assist unit using timers, shrink_timer: 200 jiffies Starting kswapd Journalled Block Device driver loaded devfs: v1.12a (20020514) Richard Gooch (rgooch@atnf.csiro.au) devfs: boot_options: 0x0 SGI XFS with no debug enabled i2c-core.o: i2c core module i2c-dev.o: i2c /dev entries driver module i2c-core.o: driver i2c-dev dummy driver registered. i2c-proc.o version 2.6.1 (20010825) PCI: Enabling device 00:10.0 (0086 -> 0087) aty128fb: Rage Mobility M3 (AGP) [chip rev 0x0] 8M 128-bit SDR SGRAM (1:1) Console: switching to colour frame buffer device 128x48 fb0: ATY Rage128 frame buffer device on PCI no framebuffer address found for /pci@f0000000/ATY,RageM3pParent@10/ATY,RageM3pB input0: Macintosh mouse button emulation pty: 256 Unix98 ptys configured Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled IN from bad port 3f9 at c018ea24 IN from bad port 3f9 at c018ea24 IN from bad port 3f9 at c018ea24 IN from bad port 2f9 at c018ea24 IN from bad port 2f9 at c018ea24 IN from bad port 2f9 at c018ea24 IN from bad port 3e9 at c018ea24 IN from bad port 3e9 at c018ea24 IN from bad port 3e9 at c018ea24 IN from bad port 2e9 at c018ea24 IN from bad port 2e9 at c018ea24 IN from bad port 2e9 at c018ea24 Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx pmac_ide: enabling IDE bus ID 2 pmac_ide: enabling IDE bus ID 1 hda: IBM-DJSA-210, ATA DISK drive ide0 at 0xd4a0f000-0xd4a0f007,0xd4a0f160 on irq 19 hda: Enabling Ultra DMA 4 ide_pmac: Set UDMA timing for mode 4, reg: 0x0c50038c hda: 19640880 sectors (10056 MB) w/384KiB Cache, CHS=19485/16/63, UDMA(66) Partition check: /dev/ide/host0/bus0/target0/lun0: [mac] p1 p2 p3 p4 p5 p6 p7 p8 p9 p10 p11 p12 RAMDISK driver initialized: 16 RAM disks of 24000K size 1024 blocksize loop: loaded (max 8 devices) sungem.c:v0.97 3/20/02 David S. Miller (davem@redhat.com) eth%d: MII PHY ID: 406210 BCM 5201 eth0: Sun GEM (PCI) 10/100/1000BaseT Ethernet 00:30:65:7f:91:9a PPP generic driver version 2.4.2 PPP Deflate Compression module registered SCSI subsystem driver Revision: 1.00 mesh: configured for synchronous 5 MB/s kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2 kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2 kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2 kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2 ieee1394: sbp2: Please load the lower level IEEE-1394 driver (e.g. ohci1394) before sbp2... Linux Kernel Card Services 3.1.22 options: [pci] [cardbus] orinoco.c 0.11b (David Gibson and others) hermes.c: 5 Apr 2002 David Gibson airport.c 0.11b (Benjamin Herrenschmidt ) macserial: i2c-modem detected, id: 1 PowerMac Z8530 serial driver version 2.0 tty00 at 0xd1ad6020 (irq = 22) is a Z8530 ESCC (internal modem) tty01 at 0xd1add000 (irq = 23) is a Z8530 ESCC (IrDA) Macintosh non-volatile memory driver v1.0 Thermal Infos found : implementation id : 1 fan_count : 1 thermostat_count : 2 ranges[0] : 72,67 ranges[1] : 72,67 ranges[2] : 0,0 ranges[3] : 0,0 i2c-core.o: driver Apple Thermostat registered. usb.c: registered new driver usbdevfs usb.c: registered new driver hub PCI: Enabling device 01:18.0 (0000 -> 0002) usb-ohci.c: USB OHCI at membase 0xd1ae3000, IRQ 27 usb-ohci.c: usb-01:18.0, Apple Computer Inc. KeyLargo USB Yenta IRQ list 0000, PCI irq58 Socket status: 30000086 adb: starting probe task... usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected PCI: Enabling device 01:19.0 (0000 -> 0002) usb-ohci.c: USB OHCI at membase 0xd1ae5000, IRQ 28 usb-ohci.c: usb-01:19.0, Apple Computer Inc. KeyLargo USB (#2) usb.c: new USB bus registered, assigned bus number 2 hub.c: USB hub found hub.c: 2 ports detected usb.c: registered new driver hid hid-core.c: v1.8.1 Andreas Gal, Vojtech Pavlik hid-core.c: USB HID support drivers usb.c: registered new driver acm acm.c: v0.21:USB Abstract Control Model driver for USB modems and ISDN adapters mice: PS/2 mouse device common for all mice i2c-dev.o: Registered 'uni-n 0' as minor 0 Thermostat 0 (uni-n 0:49), config: 00 Thermostat 0 (uni-n 0:49) failed to read temp ! i2c-core.o: adapter uni-n 0 registered as adapter 0. i2c-dev.o: Registered 'uni-n 1' as minor 1 Thermostat 1 (uni-n 1:49), config: 00 Thermostat 1 (uni-n 1:49), temp: 2280 (about: 34 degree C) i2c-core.o: client [thermostat] registered to adapter [uni-n 1](pos. 0). Thermostat 1 (uni-n 1:49), tl: 4300 (67 degree C), th: 4800 (72 degree C) i2c-core.o: adapter uni-n 1 registered as adapter 1. Found KeyWest i2c on "uni-n", 2 channels, stepping: 4 bits i2c-dev.o: Registered 'mac-io 0' as minor 2 i2c-core.o: adapter mac-io 0 registered as adapter 2. Found KeyWest i2c on "mac-io", 1 channel, stepping: 4 bits NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 2048 buckets, 16Kbytes TCP: Hash tables configured (established 16384 bind 16384) NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. adb devices: [2]: 2 c4 [3]: 3 1 [7]: 7 1f ADB keyboard at 2, handler 1 Detected ADB keyboard, type ISO, swapping keys. input1: ADB HID on ID 2:2.c4 input2: ADB HID on ID 7:7.1f ADB mouse at 3, handler set to 4 (trackpad)<5>RAMDISK: Compressed image found at block 0 Freeing initrd memory: 6458k freed EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended VFS: Mounted root (ext2 filesystem). Freeing unused kernel memory: 308k init 8k chrp 36k prep input3: ADB HID on ID 3:3.01 adb: finished probe task... eth0: MII PHY ID: 406210 BCM 5201 eth0: Link is up at 100 Mbps, full-duplex. eth0: Pause is disabled