daemonlogger.confd.1

daemonlogger.confd.1 (text/plain), 2.01 KB, created by Jason Wallace on 2010-08-10 19:57:07 UTC

# Config file for /etc/init.d/daemonlogger

# This tell daemonlogger which interface to listen on
IFACE="eth0"

# You do _NOT_ want to change this
PIDPATH="/var/run/daemonlogger"
PIDFILE="daemonlogger.pid"

# User and Group to run as
DL_USER="daemonlogger"
DL_GROUP="daemonlogger"

# Define the location of your BPF file.
BPF="/etc/daemonlogger/daemonlogger.bpf"

# Set the number of bytes to capture per packet. 
# Specify 0 (zero) to capture the full packet.
# 'man tcpdump' for more info about snaplen.
SNAP="0"

# This option determins if daemonlogger will log captured packets 
# to disk (log mode) or redirect them out a second interface (tap mode).
# Valid options are "log" or "tap"
DL_MODE="log"

##### Log Mode Options #####
# If you specified "log" above, then these options will be used
# when you start the daemonlogger init script.
#
# Directory to log pcap files to.
LOG_DIR="/var/log/daemonlogger"
#
# The pcap files can be rolled over based on size, time or both.
# If you want to use only size or time, then comment out the one you do not 
# wish to use. If you use both, then the first boundry the file reaches
# will cause the pcap file to roll over.
#
# Rollover the log file if it reaches this size in bytes.
#LOG_SIZE="1073741824"
#
# Rollover the log file on time intervals.  Append an 'm' to rollover on minute 
# boundaries, 'h' to rollover on hour boundaries and 'd' to rollover on day boundaries.
# See the README in the doc directory for more information.
LOG_TIME="1h"
#
# This option will write log files to the disk until it reaches this % utilization and 
# then roll over and delete the oldest log file.
LOG_PCT="80"
############################

##### Tap Mode Options #####
# If you specified "tap" above, then these options will be used
# when you start the daemonlogger init script.
#
# In tap mode, which interface to output packets to. This can not
# be the same as IFACE above.
TAP_OFACE="eth1"
############################


DL_OPTS="-d -i $IFACE -S $SNAP -f $BPF -u $DL_USER -g $DL_GROUP -P $PIDPATH -p $PIDFILE"