Linux version 2.4.21 (root@palantir.st.hmc.edu) (gcc version 3.2.2) #2 Tue Jun 17 16:01:03 PDT 2003
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
 BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
 BIOS-e820: 0000000000100000 - 000000001fedc000 (usable)
 BIOS-e820: 000000001fedc000 - 0000000020000000 (reserved)
 BIOS-e820: 00000000feda0000 - 00000000fee00000 (reserved)
 BIOS-e820: 00000000ffb80000 - 0000000100000000 (reserved)
510MB LOWMEM available.
On node 0 totalpages: 130780
zone(0): 4096 pages.
zone(1): 126684 pages.
zone(2): 0 pages.
Dell Latitude with broken BIOS detected. Refusing to enable the local APIC.
Kernel command line: root=/dev/hda4
Initializing CPU#0
Detected 1196.161 MHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 2385.51 BogoMIPS
Memory: 514248k/523120k available (1878k kernel code, 8484k reserved, 620k data, 112k init, 0k highmem)
Dentry cache hash table entries: 65536 (order: 7, 524288 bytes)
Inode cache hash table entries: 32768 (order: 6, 262144 bytes)
Mount cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer-cache hash table entries: 32768 (order: 5, 131072 bytes)
Page-cache hash table entries: 131072 (order: 7, 524288 bytes)
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 512K
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU:     After generic, caps: 0383f9ff 00000000 00000000 00000000
CPU:             Common caps: 0383f9ff 00000000 00000000 00000000
CPU: Intel(R) Pentium(R) III Mobile CPU      1200MHz stepping 01
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au)
mtrr: detected mtrr type: Intel
PCI: PCI BIOS revision 2.10 entry at 0xfc00e, last bus=2
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Ignoring BAR0-3 of IDE controller 00:1f.1
Transparent bridge - Intel Corp. 82801BAM/CAM PCI Bridge
PCI: Discovered primary peer bus 08 [IRQ]
PCI: Using IRQ router PIIX [8086/248c] at 00:1f.0
PCI: Found IRQ 11 for device 00:1f.1
PCI: Sharing IRQ 11 with 02:00.0
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16)
Starting kswapd
Journalled Block Device driver loaded
devfs: v1.12c (20020818) Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x1
Installing knfsd (copyright (C) 1996 okir@monad.swb.de).
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
PCI: Found IRQ 11 for device 00:1f.6
PCI: Sharing IRQ 11 with 00:1f.5
PCI: Sharing IRQ 11 with 02:03.0
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
Linux agpgart interface v0.99 (c) Jeff Hartmann
agpgart: Maximum main memory to use for agp memory: 438M
agpgart: Detected an Intel 830M Chipset.
agpgart: detected 892K stolen memory.
agpgart: AGP aperture is 128M @ 0xe0000000
[drm] Initialized tdfx 1.0.0 20010216 on minor 0
[drm] AGP 0.99 on Intel i810 @ 0xe0000000 128MB
[drm] Initialized radeon 1.1.1 20010405 on minor 1
[drm] AGP 0.99 on Intel i810 @ 0xe0000000 128MB
[drm] Initialized i810 1.2.0 20010920 on minor 2
[drm] AGP 0.99 on Intel i810 @ 0xe0000000 128MB
[drm] Initialized i830 1.2.0 20011004 on minor 3
Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ICH3M: IDE controller at PCI slot 00:1f.1
PCI: Enabling device 00:1f.1 (0005 -> 0007)
PCI: Found IRQ 11 for device 00:1f.1
PCI: Sharing IRQ 11 with 02:00.0
ICH3M: chipset revision 2
ICH3M: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0xbfa0-0xbfa7, BIOS settings: hda:DMA, hdb:pio
hda: IC25N020ATCS04-0, ATA DISK drive
blk: queue c03b77e0, I/O limit 4095Mb (mask 0xffffffff)
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: attached ide-disk driver.
hda: host protected area => 1
hda: 39070080 sectors (20004 MB) w/1768KiB Cache, CHS=2432/255/63, UDMA(100)
Partition check:
 /dev/ide/host0/bus0/target0/lun0: p1 p2 p3 p4
SCSI subsystem driver Revision: 1.00
kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2
Linux Kernel Card Services 3.1.22
  options:  [pci] [cardbus] [pm]
PCI: Found IRQ 11 for device 02:01.0
PCI: Found IRQ 11 for device 02:03.0
PCI: Sharing IRQ 11 with 00:1f.5
PCI: Sharing IRQ 11 with 00:1f.6
usb.c: registered new driver hub
Yenta IRQ list 06b8, PCI irq11
Socket status: 30000006
Yenta IRQ list 0000, PCI irq11
Socket status: 30000010
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
USB Mass Storage support registered.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 4096 buckets, 32Kbytes
TCP: Hash tables configured (established 32768 bind 65536)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
reiserfs: checking transaction log (device 03:04) ...
Using r5 hash to sort names
ReiserFS version 3.6.25
VFS: Mounted root (reiserfs filesystem) readonly.
Mounted devfs on /dev
Freeing unused kernel memory: 112k freed
Adding Swap: 498004k swap-space (priority -1)
xsvc: v3.0 (devrel@xig.com) [$XiGDate: 2002/07/01 20:37:29 $]
xsvc: Intel 830, 64MB at 0xe0000000 (00000000/00)
PCI: Found IRQ 11 for device 02:00.0
PCI: Sharing IRQ 11 with 00:1f.1
3c59x: Donald Becker and others. www.scyld.com/network/vortex.html
See Documentation/networking/vortex.txt
02:00.0: 3Com PCI 3c905C Tornado at 0xec80. Vers LK1.1.16
 00:08:74:21:14:93, IRQ 11
  product code 0000 rev 00.6 date 06-20-02
  Internal config register is 1840000, transceivers 0xa.
  8K byte-wide RAM 5:3 Rx:Tx split, autoselect/Autonegotiate interface.
  MII transceiver found at address 24, status 782d.
  Enabling bus-master transmits and whole-frame receives.
02:00.0: scatter/gather enabled. h/w checksums enabled
PCI: Found IRQ 11 for device 00:1f.5
PCI: Sharing IRQ 11 with 00:1f.6
PCI: Sharing IRQ 11 with 02:03.0
PCI: Setting latency timer of device 00:1f.5 to 64
cs: IO port probe 0x0c00-0x0cff: clean.
cs: IO port probe 0x0800-0x08ff: excluding 0x800-0x817 0x828-0x837 0x840-0x84f 0x860-0x877 0x880-0x88f 0x898-0x89f 0x8a8-0x8af 0x8b8-0x8cf 0x8e0-0x8ff
cs: IO port probe 0x0100-0x04ff: excluding 0x280-0x287 0x378-0x37f 0x4d0-0x4d7
cs: IO port probe 0x0a00-0x0aff: clean.
intel8x0: clocking to 48000
uhci.c: USB Universal Host Controller Interface driver v1.1
PCI: Found IRQ 11 for device 00:1d.0
PCI: Sharing IRQ 11 with 00:02.0
PCI: Setting latency timer of device 00:1d.0 to 64
uhci.c: USB UHCI at I/O 0xbf80, IRQ 11
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
/dev/vmmon: Module vmmon: registered with major=10 minor=165 tag=$Name: build-2242 $
/dev/vmmon: Module vmmon: initialized
parport0: PC-style at 0x378 (0x778) [PCSPP(,...)]
parport0: irq 7 detected
/dev/vmnet: open called by PID 1736 (vmnet-bridge)
/dev/vmnet: hub 0 does not exist, allocating memory.
/dev/vmnet: port on hub 0 successfully opened
bridge-eth0: up
bridge-eth0: attached
/dev/vmnet: open called by PID 1766 (vmnet-natd)
/dev/vmnet: hub 8 does not exist, allocating memory.
/dev/vmnet: port on hub 8 successfully opened
/dev/vmnet: open called by PID 2130 (vmnet-netifup)
/dev/vmnet: port on hub 8 successfully opened
/dev/vmnet: open called by PID 2144 (vmnet-dhcpd)
/dev/vmnet: port on hub 8 successfully opened