dmesg vanilla Linux 2.6.23_rc7

dmesg (text/plain), 7.51 KB, created by Florian Steinel on 2007-10-14 11:51:36 UTC

Using CHRP machine description
Total memory = 512MB; using 1024kB for hash table (at cff00000)
Linux version 2.6.23-rc7 (root@pegasos) (gcc version 4.1.2 (Gentoo 4.1.2)) #1 Sat Sep 22 14:28:21 CEST 2007
Found legacy serial port 0 for /pci@80000000/isa@C/serial@i2F8
  port=2f8, taddr=fe0002f8, irq=0, clk=1843200, speed=0
console [udbg0] enabled
Entering add_active_range(0, 0, 131072) 0 entries of 256 used
chrp type = 6 [Genesi Pegasos]
Pegasos l2cr : L2 cache was not active, activating
PCI bus 0 controlled by /pci@80000000 at 80000000
PCI bus 0 controlled by /pci@C0000000 at c0000000
Top of RAM: 0x20000000, Total RAM: 0x20000000
Memory hole size: 0MB
Zone PFN ranges:
  DMA             0 ->   131072
  Normal     131072 ->   131072
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
    0:        0 ->   131072
On node 0 totalpages: 131072
  DMA zone: 1024 pages used for memmap
  DMA zone: 0 pages reserved
  DMA zone: 130048 pages, LIFO batch:31
  Normal zone: 0 pages used for memmap
  Movable zone: 0 pages used for memmap
Built 1 zonelists in Zone order.  Total pages: 130048
Kernel command line: root=/dev/hda4 
i8259 legacy interrupt controller initialized
PID hash table entries: 2048 (order: 11, 8192 bytes)
time_init: decrementer frequency = 33.333333 MHz
time_init: processor frequency   = 999.999990 MHz
Console: colour dummy device 80x25
console handover: boot [udbg0] -> real [tty0]
Dentry cache hash table entries: 65536 (order: 6, 262144 bytes)
Inode-cache hash table entries: 32768 (order: 5, 131072 bytes)
Memory: 514560k/524288k available (3268k kernel code, 9304k reserved, 144k data, 148k bss, 168k init)
Calibrating delay loop... 66.56 BogoMIPS (lpj=133120)
Security Framework v1.0.0 initialized
SELinux:  Disabled at boot.
Capability LSM initialized
Mount-cache hash table entries: 512
NET: Registered protocol family 16
PCI: Probing PCI hardware
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
NET: Registered protocol family 2
IP route cache hash table entries: 16384 (order: 4, 65536 bytes)
TCP established hash table entries: 65536 (order: 7, 524288 bytes)
TCP bind hash table entries: 65536 (order: 6, 262144 bytes)
TCP: Hash tables configured (established 65536 bind 65536)
TCP reno registered
audit: initializing netlink socket (disabled)
audit(52738572.196:1): initialized
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered (default)
radeonfb: Found Intel x86 BIOS ROM Image
radeonfb: No ATY,RefCLK property !
radeonfb: Retrieved PLL infos from BIOS
radeonfb: Reference=27.00 MHz (RefDiv=12) Memory=250.00 Mhz, System=200.00 MHz
radeonfb: PLL min 20000 max 40000
i2c-adapter i2c-1: unable to read EDID block.
i2c-adapter i2c-1: unable to read EDID block.
i2c-adapter i2c-1: unable to read EDID block.
i2c-adapter i2c-3: unable to read EDID block.
i2c-adapter i2c-3: unable to read EDID block.
i2c-adapter i2c-3: unable to read EDID block.
i2c-adapter i2c-2: unable to read EDID block.
i2c-adapter i2c-2: unable to read EDID block.
i2c-adapter i2c-2: unable to read EDID block.
i2c-adapter i2c-3: unable to read EDID block.
i2c-adapter i2c-3: unable to read EDID block.
i2c-adapter i2c-3: unable to read EDID block.
radeonfb: Monitor 1 type CRT found
radeonfb: Monitor 2 type no found
Console: switching to colour frame buffer device 80x30
radeonfb (0001:01:08.0): ATI Radeon If 
Generic RTC Driver v1.07
Macintosh non-volatile memory driver v1.1
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled
serial8250.0: ttyS0 at I/O 0x2f8 (irq = 0) is a 16550A
RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize
via-rhine.c:v1.10-LK1.4.3 2007-03-06 Written by Donald Becker
PCI: Enabling device 0000:00:0d.0 (0000 -> 0003)
eth0: VIA Rhine II at 0x80000800, 00:0b:2f:47:3a:d6, IRQ 9.
eth0: MII PHY found at address 16, status 0x786d advertising 01e1 Link 45e1.
MV-643xx 10/100/1000 Ethernet Driver
eth1: port 1 with MAC address 00:00:00:00:00:00
eth1: Scatter Gather Enabled
eth1: TX TCP/IP Checksumming Supported
eth1: RX TCP/UDP Checksum Offload ON 
eth1: RX NAPI Enabled 
eth1: Using SRAM
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: IDE controller at PCI slot 0000:00:0c.1
VP_IDE: chipset revision 6
VP_IDE: VIA vt8231 (rev 10) IDE UDMA100 controller on pci0000:00:0c.1
VP_IDE: 100% native mode on irq 14
    ide0: BM-DMA at 0x1020-0x1027, BIOS settings: hda:pio, hdb:pio
    ide1: BM-DMA at 0x1028-0x102f, BIOS settings: hdc:pio, hdd:pio
Probing IDE interface ide0...
hda: SAMSUNG SP1203N, ATA DISK drive
hda: selected mode 0x45
ide0 at 0x1000-0x1007,0x100e on irq 14
Probing IDE interface ide1...
hdd: Pioneer CD-ROM ATAPI Model DR-A14S 0104, ATAPI CD/DVD-ROM drive
hdd: selected mode 0x22
ide1 at 0x1010-0x1017,0x101e on irq 15
hda: max request size: 512KiB
hda: 234493056 sectors (120060 MB) w/2048KiB Cache, CHS=16383/255/63, UDMA(100)
hda: cache flushes supported
 hda: RDSK (512) hda1 (DOS^A)(res 2 spb 1) hda2 (SFS^@)(res 2 spb 2) hda3 (SWP^@)(res 2 spb 1) hda4 (LNX^@)(res 2 spb 1)
hdd: ATAPI 32X CD-ROM drive, 128kB Cache, DMA
Uniform CD-ROM driver Revision: 3.20
ohci_hcd: 2006 August 04 USB 1.1 'Open' Host Controller (OHCI) Driver
USB Universal Host Controller Interface driver v3.0
uhci_hcd 0000:00:0c.2: UHCI Host Controller
uhci_hcd 0000:00:0c.2: new USB bus registered, assigned bus number 1
uhci_hcd 0000:00:0c.2: irq 9, io base 0x00001040
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
uhci_hcd 0000:00:0c.3: UHCI Host Controller
uhci_hcd 0000:00:0c.3: new USB bus registered, assigned bus number 2
uhci_hcd 0000:00:0c.3: irq 9, io base 0x00001060
usb usb2: configuration #1 chosen from 1 choice
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 2 ports detected
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
mice: PS/2 mouse device common for all mice
EDAC MC: Ver: 2.1.0 Sep 22 2007
usbcore: registered new interface driver hiddev
usbcore: registered new interface driver usbhid
drivers/hid/usbhid/hid-core.c: v2.6:USB HID core driver
TCP cubic registered
NET: Registered protocol family 1
drivers/rtc/hctosys.c: unable to open rtc device (rtc0)
EXT3-fs: INFO: recovery required on readonly filesystem.
EXT3-fs: write access will be enabled during recovery.
kjournald starting.  Commit interval 5 seconds
EXT3-fs: recovery complete.
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem) readonly.
Freeing unused kernel memory: 168k init
vt596_smbus 0000:00:0c.4: SMBUS: Error: Host SMBus controller not enabled! - upgrade BIOS or use force=1
parport_pc: VIA 686A/8231 detected
parport_pc: probing current configuration
parport_pc: Current parallel port base: 0x3BC
parport0: PC-style at 0x3bc, irq 7 [PCSPP]
parport_pc: VIA parallel port: io=0x3BC, irq=7
PCI: Enabling device 0000:00:01.0 (0000 -> 0003)
ohci1394: fw-host0: OHCI-1394 1.0 (PCI): IRQ=[9]  MMIO=[80000000-800007ff]  Max Packet=[2048]  IR/IT contexts=[8/8]
PCI: Enabling device 0000:00:0c.5 (0000 -> 0001)
EXT3 FS on hda4, internal journal
ieee1394: Host added: ID:BUS[0-00:1023]  GUID[0011060000004b2f]
Adding 2061064k swap on /dev/hda3.  Priority:-1 extents:1 across:2061064k
eth0: link up, 100Mbps, full-duplex, lpa 0x45E1
NET: Registered protocol family 17
NET: Registered protocol family 10
lo: Disabled Privacy Extensions
eth0: no IPv6 routers present