poppler-0.1.1.ebuild

poppler-0.1.1.ebuild (text/plain), 1.73 KB, created by Marien Zwart (RETIRED) on 2005-03-02 16:01:08 UTC

# Copyright 1999-2004 Gentoo Foundation
# Distributed under the terms of the GNU General Public License v2
# $Header: $

inherit eutils

DESCRIPTION="Poppler is a PDF rendering library based on the xpdf-3.0 code base."
HOMEPAGE="http://freedesktop.org/wiki/Software_2fpoppler/"
SRC_URI="http://freedesktop.org/~krh/${P}.tar.gz"
LICENSE="GPL-2"
SLOT="0"

KEYWORDS="~x86"
IUSE="a4 opi splash cairo test"

DEPEND=""

# Run-time dependencies, same as DEPEND if RDEPEND isn't defined:
#RDEPEND=""

# If you don't need to change it, leave the S= line out of the ebuild
# to keep it tidy.
S=${WORKDIR}/${P}

src_compile() {
	local myconf="$(use_enable a4 a4-paper)"
	myconf="${myconf} $(use_enable opi)"
	myconf="${myconf} $(use_enable splash splash_output)"
	myconf="${myconf} $(use_enable cairo cairo-output)"
	myconf="${myconf} $(use_enable test gtk-test)"
	econf ${myconf} || die "econf failed"

	emake || die "emake failed"
}

src_install() {
	# You must *personally verify* that this trick doesn't install
	# anything outside of DESTDIR; do this by reading and
	# understanding the install part of the Makefiles.
	# This is the preferred way to install.
	make DESTDIR=${D} install || die

	# For Makefiles that don't make proper use of DESTDIR, setting
	# prefix is often an alternative.  However if you do this, then
	# you also need to specify mandir and infodir, since they were
	# passed to ./configure as absolute paths (overriding the prefix
	# setting).
	#make \
	#	prefix=${D}/usr \
	#	mandir=${D}/usr/share/man \
	#	infodir=${D}/usr/share/info \
	#	libdir=${D}/usr/$(get_libdir) \
	#	install || die
	# Again, verify the Makefiles!  We don't want anything falling
	# outside of ${D}.

	# The portage shortcut to the above command is simply:
	#
	#einstall || die
}