wpa_supplicant v1.0
random: Trying to read entropy from /dev/random
Initializing interface 'eth1' conf '/etc/wpa_supplicant/wpa_supplicant.conf' driver 'nl80211' ctrl_interface 'N/A' bridge 'N/A'
Configuration file '/etc/wpa_supplicant/wpa_supplicant.conf' -> '/etc/wpa_supplicant/wpa_supplicant.conf'
Reading configuration file '/etc/wpa_supplicant/wpa_supplicant.conf'
ctrl_interface_group='wheel'
ctrl_interface='/var/run/wpa_supplicant'
ap_scan=1
Priority group 0
   id=0 ssid='milk'
   id=1 ssid='cookies'
   id=2 ssid='dlink'
   id=3 ssid='TVFIRE'
   id=4 ssid='camshaft'
nl80211: interface eth1 in phy phy0
rfkill: initial event: idx=0 type=1 op=0 soft=0 hard=0
rfkill: initial event: idx=1 type=2 op=0 soft=0 hard=0
rfkill: initial event: idx=2 type=1 op=0 soft=0 hard=0
rfkill: initial event: idx=3 type=2 op=0 soft=0 hard=0
nl80211: Set mode ifindex 3 iftype 2 (STATION)
netlink: Operstate: linkmode=1, operstate=5
nl80211: Register frame command failed (type=208): ret=-95 (Operation not supported)
nl80211: Register frame match - hexdump(len=1): 06
nl80211: Failed to register Action frame processing - ignore for now
nl80211: driver param='(null)'
nl80211: Regulatory information - country=00
nl80211: 2402-2472 @ 40 MHz
nl80211: 2457-2482 @ 20 MHz
nl80211: 2474-2494 @ 20 MHz
nl80211: 5170-5250 @ 40 MHz
nl80211: 5735-5835 @ 40 MHz
nl80211: Added 802.11b mode based on 802.11g information
wpa_driver_nl80211_set_key: ifindex=3 alg=0 addr=(nil) key_idx=0 set_tx=0 seq_len=0 key_len=0
wpa_driver_nl80211_set_key: ifindex=3 alg=0 addr=(nil) key_idx=1 set_tx=0 seq_len=0 key_len=0
wpa_driver_nl80211_set_key: ifindex=3 alg=0 addr=(nil) key_idx=2 set_tx=0 seq_len=0 key_len=0
wpa_driver_nl80211_set_key: ifindex=3 alg=0 addr=(nil) key_idx=3 set_tx=0 seq_len=0 key_len=0
eth1: RSN: flushing PMKID list in the driver
nl80211: Flush PMKIDs
eth1: Setting scan request: 0 sec 100000 usec
EAPOL: SUPP_PAE entering state DISCONNECTED
EAPOL: Supplicant port status: Unauthorized
EAPOL: KEY_RX entering state NO_KEY_RECEIVE
EAPOL: SUPP_BE entering state INITIALIZE
EAP: EAP entering state DISABLED
EAPOL: Supplicant port status: Unauthorized
EAPOL: Supplicant port status: Unauthorized
ctrl_interface_group=10 (from group name 'wheel')
eth1: Added interface eth1
random: Got 20/20 bytes from /dev/random
RTM_NEWLINK: operstate=0 ifi_flags=0x11043 ([UP][RUNNING][LOWER_UP])
RTM_NEWLINK, IFLA_IFNAME: Interface 'eth1' added
nl80211: if_removed already cleared - ignore event
RTM_NEWLINK: operstate=0 ifi_flags=0x11003 ([UP][LOWER_UP])
RTM_NEWLINK, IFLA_IFNAME: Interface 'eth1' added
nl80211: if_removed already cleared - ignore event
eth1: State: DISCONNECTED -> SCANNING
Scan SSID - hexdump_ascii(len=7):
     63 6f 6f 6b 69 65 73                              cookies         
eth1: Starting AP scan for specific SSID(s)
Scan requested (ret=0) - scan timeout 10 seconds
nl80211: Event message available
nl80211: Scan trigger
EAPOL: disable timer tick
EAPOL: Supplicant port status: Unauthorized
nl80211: Event message available
nl80211: New scan results available
eth1: Event SCAN_RESULTS (3) received
nl80211: Received scan results (0 BSSes)
eth1: BSS: Start scan result update 1
eth1: New scan results available
eth1: Selecting BSS from priority group 0
eth1: No suitable network found
eth1: Setting scan request: 5 sec 0 usec
eth1: Checking for other virtual interfaces sharing same radio (phy0) in event_scan_results
RTM_NEWLINK: operstate=0 ifi_flags=0x11003 ([UP][LOWER_UP])
RTM_NEWLINK, IFLA_IFNAME: Interface 'eth1' added
nl80211: if_removed already cleared - ignore event
eth1: Starting AP scan for wildcard SSID
Scan requested (ret=0) - scan timeout 30 seconds
nl80211: Event message available
nl80211: Scan trigger
nl80211: Event message available
nl80211: New scan results available
eth1: Event SCAN_RESULTS (3) received
nl80211: Received scan results (2 BSSes)
eth1: BSS: Start scan result update 2
eth1: BSS: Add new id 0 BSSID 00:1e:2a:02:ed:84 SSID ''
eth1: BSS: Add new id 1 BSSID 00:22:3f:04:d0:70 SSID ''
eth1: New scan results available
eth1: Selecting BSS from priority group 0
eth1: 0: 00:1e:2a:02:ed:84 ssid='' wpa_ie_len=0 rsn_ie_len=0 caps=0x401 level=-43
eth1:    skip - SSID mismatch
eth1:    skip - SSID mismatch
eth1:    skip - SSID mismatch
eth1:    skip - SSID mismatch
eth1:    skip - SSID mismatch
eth1: 1: 00:22:3f:04:d0:70 ssid='' wpa_ie_len=0 rsn_ie_len=0 caps=0x521 level=-81
eth1:    skip - SSID not known
eth1: No suitable network found